1911 PX™-04 Standard Size - CNC Pistol Grips (Sunrise Pattern, Matte Finish)

National Tactical Officers Association Approved
NTOA Overall Rating: 4.68 / 5.00
Read Full Review »

Polymer Extreme CNC 1911 Pistol Grips
Sunrise Pattern, Matte Finish
Model: PX-04

The sunrise pattern gives these grips and your handgun a modern yet refined look. These grips are bead blasted and feature a subtle matte finish. The sunrise pattern is downright gorgeous and were inspired by the Japanese “Rising Sun Flag” or “旭日旗 (Kyokujitsu-ki)”.

The POLYMER EXTREME (PX) series 1911 pistol grips are constructed of heat resistant, high impact, and high bending strength polymers. These grips are inspired by Ray Gorzyn who is an accomplished 1911 gunsmith with over 30+ years of experience and an active IPSC shooter. Hundreds of 1911 have been custom built and produced by Ray and are considered top of the line.

Note that our matte finish grips are a dull matte black and look more grey. Simply take some light silicone spray and magically they turn into a smooth jet black.
All our 1911 grips are conveniently pre-cut for ambi safeties.

Specifications (Based on the JIS K6911 standard)

- Thickness: 0.295" (0.749cm)
- Density: 1.42
- Water Absorption: 0.3%
- Molded Shrinkage: 0.7%-1.25%
- Heat Resistance:(2hr/'C): 200'C
- Impact Strength: 3.0-3.5 Kgf-cm/cm2
- Flexible Strength: 9.5 Kgf/mm2
- Tensile Strength: 5.6 Kgf/mm2
- Compressive Strength: 22.0 Kgf/mm2
- Isolation Resistance: 1x5^(8-9)Ω (ohm)
- Breakdown Voltage: 11.0Kv/mm

NOTE:Cannot fit on SLIMLINE SCREWS/STANDARD BUSHINGS combination

NOTE: SI PX™ Grips Fit 1911 Full Size (Government Size) Model 

-CALIFORNIA PROPOSITION 65 WARNING:-
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information: www.P65Warnings.ca.gov